Where is the water actually coming from?
Start by locating the leak's origin — front, back, or underneath. A leak visible at the front of a front-load washer during the wash cycle almost always points to the door gasket. A leak at the back or underneath usually traces to a hose connection or the drain pump itself.
What if it's leaking from the door on a front-loader?
Check the rubber door gasket for tears, trapped debris, or a buildup of detergent residue that's keeping it from sealing fully — a common issue if you use more detergent than the 'HE' line calls for, which is a mistake we see often with hard North Texas water requiring extra suds to feel 'clean.' A damaged gasket is a straightforward $90–$170 repair.
What if it's leaking from the hoses?
Inlet and drain hose connections loosen over time, especially if the washer has been shifted during a move or a flooring change. Check that both hose clamps are snug and that the hoses themselves aren't cracked — hoses over 8–10 years old are worth replacing proactively even if they aren't leaking yet, since rubber degrades with age regardless of use.
What if the hoses and gasket both look fine?
That shifts suspicion to the drain pump, which can develop a small crack or a failed seal over time — this shows up as a slow drip near the bottom of the machine rather than a leak during the wash itself, and typically runs $110–$190 to replace.
Call (469) 886-1122 and we'll pinpoint the source same day, before it causes floor or subfloor damage.